36mm Pancake Stepper Motor NEMA14 compatible with Creality CR10, Ender 3
Features high temperature resistance and a quiet 22dB operating sound, ideal for compact extruder setups.
Key facts
- Part type
- Stepper Motor
- Type
- Aftermarket replacement
Compatibility matrix
Only models verified by our team are listed| Parts for | Model | This part |
|---|---|---|
| Creality | Creality CR10 | Fits |
| Creality Ender 3 | Fits |
Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.
Where to find your model number
- Creality: Usually on the rating label under or on the back of the device. Your owner's manual also lists the model number.
General manufacturer guidance: exact label position can vary by model.
Stepper Motor specifications
- Step Angle
- 1.8±5% /STEP
- Current
- 1.88A/PHASE
- Weight
- 98g
- Dimensions
- 51x36x23MM
- Teeth
- 10 teeth
- Cable Length
- 70cm extension included
Installation guide - General replacement guidance
General guidance for this part type - always follow your device manual- Basic hand tools, only if your manual requires them
- If anything does not fit without force, stop and recheck the model on this page.
- Keep the old part until the new one is confirmed working.
- 1Switch off and unplug. Disconnect the device from power and let hot parts cool.
- 2Find the part. Check your device manual for the access panel, latches or screws; photograph each step as you go.
- 3Remove the old part. Note its orientation and any connectors, and release connectors by their plug body, never the wires.
- 4Compare and fit. Hold the old and new parts side by side, then fit the new one the same way round without forcing it.
- 5Reassemble and test. Refit covers, reconnect power and run a short test before regular use.
This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.
More parts for Creality CR10
See all Creality CR10 parts
More parts for Creality Ender 3
See all Creality Ender 3 parts
12 month warranty on every part
Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.
Customer reviews
No reviews yet
Bought this part? Be the first to share how it fit and how it held up.
Questions & answers
+Which models does this stepper motor fit?
Our team verified it for Creality CR10, Creality Ender 3. The full list is in the compatibility table above.
+How do I make sure it fits my exact model?
Find the model number on your device label and compare it with the table above. Our fit guarantee covers verified models.
+What are the dimensions?
Listed size: 51x36x23MM. Measure your old stepper motor to compare.
+How much does it weigh?
Listed weight: 98g.
+Is it hard to install?
Install difficulty: Moderate · basic hand tools. Step by step instructions are on this page.
+How fast will it arrive?
US orders arrive in 7 to 15 business days with free shipping. Other countries are shown at checkout.
+Is there a warranty?
Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.