Timing Belt GT2 compatible with Creality CR10, Ender 3
A 2-meter GT2 timing belt featuring a 6mm width and steel-reinforced PU core.
Key facts
- Part type
- GT2 Timing Belt
- Included
- 2 Meters
- Type
- Aftermarket replacement
Compatibility matrix
Only models verified by our team are listed| Parts for | Model | This part |
|---|---|---|
| Creality | Creality CR10 | Fits |
| Creality Ender 3 | Fits |
Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.
Where to find your model number
- Creality: Usually on the rating label under or on the back of the device. Your owner's manual also lists the model number.
General manufacturer guidance: exact label position can vary by model.
GT2 Timing Belt specifications
- Material
- PU with Steel Core
- Width
- 6mm
- Pitch
- 2mm (GT2)
- Length
- 2 Meters
Installation guide - Replacing a drive belt
General guidance for this part type - always follow your device manual- Screwdriver for the access plate
- A new belt feels tight; that is normal and it beds in after a short run.
- 1Switch off and unplug. Disconnect power before touching any belt.
- 2Open the access plate. Remove the screws of the cover over the belt and photograph how the belt is routed.
- 3Remove the old belt. Slip it off the motor pulley first, then off the driven roller or pulley.
- 4Fit the new belt. Loop it over the motor pulley, then stretch it onto the second pulley following your photo.
- 5Check and close. Turn the belt by hand to center it and confirm nothing rubs, then refit the cover.
This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.
Maintenance check
Signs it's time to replace
- 01Rattling noise from the engine, especially at cold start (chains)
- 02Check engine light with cam/crank correlation codes
- 03Misfires or rough running
- 04Belt is cracked, frayed or past its service interval in your owner's manual
More parts for Creality CR10
See all Creality CR10 parts
More parts for Creality Ender 3
See all Creality Ender 3 parts
12 month warranty on every part
Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.
Customer reviews
No reviews yet
Bought this part? Be the first to share how it fit and how it held up.
Questions & answers
+Which models does this gt2 timing belt fit?
Our team verified it for Creality CR10, Creality Ender 3. The full list is in the compatibility table above.
+How do I make sure it fits my exact model?
Find the model number on your device label and compare it with the table above. Our fit guarantee covers verified models.
+What's in the box?
Pack size: 2 Meters, as listed for this part. Check the photos and specifications for the exact contents.
+What is the gt2 timing belt made of?
Listed material: PU with Steel Core.
+What are the dimensions?
Listed size: 2 Meters. Measure your old gt2 timing belt to compare.
+Is it hard to install?
Install difficulty: Moderate · basic hand tools. Step by step instructions are on this page.
+How fast will it arrive?
US orders arrive in 7 to 15 business days with free shipping. Other countries are shown at checkout.
+Is there a warranty?
Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.