Brass 1.0mm Nozzle MK8 5-Pack compatible with Creality CR10, CR10S
Set of 5 brass MK8 extruder print head nozzles with a 1.0mm diameter for 1.75mm filament.
Key facts
- Part type
- Nozzle
- Included
- 5-pack
- Type
- Aftermarket replacement
Compatibility matrix
Only models verified by our team are listed| Parts for | Model | This part |
|---|---|---|
| Creality | Creality CR10 | Fits |
| Creality CR10S | Fits |
Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.
Where to find your model number
- Creality: Usually on the rating label under or on the back of the device. Your owner's manual also lists the model number.
General manufacturer guidance: exact label position can vary by model.
Nozzle specifications
- Material
- Brass
- Nozzle Diameter
- 1.0mm
- Filament Diameter
- 1.75mm
- Screw Diameter
- 6mm
- Dimensions
- 13mm x 6mm
- Nozzle Type
- MK8
Installation guide - General replacement guidance
General guidance for this part type - always follow your device manual- Basic hand tools, only if your manual requires them
- If anything does not fit without force, stop and recheck the model on this page.
- Keep the old part until the new one is confirmed working.
- 1Switch off and unplug. Disconnect the device from power and let hot parts cool.
- 2Find the part. Check your device manual for the access panel, latches or screws; photograph each step as you go.
- 3Remove the old part. Note its orientation and any connectors, and release connectors by their plug body, never the wires.
- 4Compare and fit. Hold the old and new parts side by side, then fit the new one the same way round without forcing it.
- 5Reassemble and test. Refit covers, reconnect power and run a short test before regular use.
This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.
Maintenance check
Signs it's time to replace
- 01Under-extrusion or inconsistent lines
- 02Clogging that cleaning does not fix
- 03Worn or enlarged nozzle opening
More parts for Creality CR10
See all Creality CR10 parts
More parts for Creality CR10S
See all Creality CR10S parts
12 month warranty on every part
Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.
Customer reviews
No reviews yet
Bought this part? Be the first to share how it fit and how it held up.
Questions & answers
+Which models does this nozzle fit?
Our team verified it for Creality CR10, Creality CR10S. The full list is in the compatibility table above.
+How do I make sure it fits my exact model?
Find the model number on your device label and compare it with the table above. Our fit guarantee covers verified models.
+What's in the box?
Pack size: 5-pack, as listed for this part. Check the photos and specifications for the exact contents.
+What is the nozzle made of?
Listed material: Brass.
+What are the dimensions?
Listed size: 13mm x 6mm. Measure your old nozzle to compare.
+Is it hard to install?
Install difficulty: Easy · no tools, a few minutes. Step by step instructions are on this page.
+How fast will it arrive?
US orders arrive in 7 to 15 business days with free shipping. Other countries are shown at checkout.
+Is there a warranty?
Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.