Skip to content
Fitly Parts

How to Replace a Vacuum Battery

Rechargeable batteries lose capacity over time, that is chemistry, not a fault. When runtime drops to a fraction of what it was, a fresh battery pack restores it. On most cordless vacuums and robots the pack swaps in minutes.

1
FIG · Replacing a batteryNTS

These are general instructions. Exact access panels, latches and part orientation vary by model, always follow your device manufacturer's manual first.

When to replace it

  • Runtime is much shorter than when the device was new
  • The device dies suddenly even though the indicator showed charge
  • The battery takes far longer to charge, or never reaches full
  • The pack is swollen, hot or damaged, stop using it immediately

What you need

  • Small screwdriver, only if the battery cover is screwed shut

Step by step

  1. 1

    Switch off and unplug. Turn the device off (robot vacuums: switch off the main power switch) and disconnect the charger.

  2. 2

    Open the battery compartment. Most use a sliding door, a latch, or a cover with two small screws on the underside. Battery packs on tools and vacuums slide out after pressing the release button.

  3. 3

    Remove the old battery. Lift it out by its tab. If it has a plug, squeeze the plug's latch and pull the plug body, never the wires.

  4. 4

    Fit the new battery. Place it the same way round, push the plug in until it clicks and make sure the battery sits flat without pinching wires.

  5. 5

    Close and charge. Refit the cover and charge to full before first use.

  • Tip: Match the voltage and battery code printed on the old battery.
  • Tip: If the device does not power on, reseat the plug before assuming a fault.
  • Tip: If the old battery is swollen, do not press, bend or puncture it. Tape over its contacts and take it to a battery recycling point; never put it in household trash.

Common mistakes to avoid

  • Pulling the connector by its wires instead of the plug housing
  • Buying by voltage alone, the connector shape and mounting must also match your exact model
  • Throwing the old battery in household trash, lithium packs must go to battery recycling
  • Leaving the new pack uncharged for weeks before first use

Pro tips from manufacturers & repair experts

  • Never put lithium-ion batteries in household trash or curbside recycling, they can start fires.
  • Tape over the terminals or bag each old battery separately before drop-off.
  • Treat swollen, leaking, corroded or scorched batteries as damaged: stop using them and keep them apart from others.
  • Take used batteries to a dedicated battery recycling or household hazardous waste drop-off.

Frequently asked questions

How do I dispose of the old battery?

Take it to an approved battery recycling point, most hardware stores and many supermarkets have one. Never put lithium batteries in household trash.

The device still will not turn on with the new battery. What now?

Reseat the connector first, a half-seated plug is the most common cause. Charge the pack fully, then try again before assuming a fault.

Should I fully charge before first use?

Yes. Give the new pack a full charge before the first cleaning session.

Need the part?

Browse compatible aftermarket options and match them to your exact model.

Find vacuum battery parts

Sources & further reading

Fitly Parts sells independent aftermarket replacement parts. Brand names are used only to identify compatible models and do not imply manufacturer affiliation.

Car with replacement cabin filter and wiper blades in a workshop

Cars & Auto

Looking for a part for your car?

Explore aftermarket car parts by category and make, matched to your exact model.

Explore Cars & Auto