1800mAh 3.6V Rechargeable Battery compatible with Sony PSP 2000 Series, PSP 3000 Series, PSP-S110 (Real 1800mAh)
Key facts
- Part type
- Console Battery
- Type
- Aftermarket replacement
Compatibility matrix
Only models verified by our team are listed| Parts for | Model | This part |
|---|---|---|
| Sony | Sony PSP 3000 Series | Fits |
| Sony PSP 2000 Series | Fits | |
| Sony PSP-S110 | Fits |
Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.
Where to find your model number
- Sony: Usually on the rating label under or on the back of the device. Your owner's manual also lists the model number.
General manufacturer guidance: exact label position can vary by model.
Console Battery specifications
- Capacity
- 1800mAh
- Voltage
- 3.6V / 3.7V
- Chemistry
- Lithium-ion (Li-ion)
- Compatible Part Number
- PSP-S360
Installation guide - Replacing a console or controller battery
General guidance for this part type - always follow your device manual- Tri-wing or Phillips screwdriver as your console uses
- Plastic spudger and plastic card
- Isopropyl alcohol for glued batteries
- If the old battery is swollen, do not press, bend or puncture it. Tape over its contacts and take it to a battery recycling point; never put it in household trash.
- 1Switch fully off. Turn the console or controller completely off, not into sleep mode.
- 2Open the back. Remove the back screws and lift the back cover off; controllers often have hidden clips along the grips.
- 3Disconnect the old battery. Pull its plug straight out of the socket by the plug body, or lift it with the spudger. Never pull on the wires.
- 4Swap the battery. Glued batteries (as in many handhelds) need isopropyl alcohol around the edges and a plastic card to lift; clip in batteries simply lift out. Fit the new one the same way round.
- 5Close and charge. Connect the new battery, close the case and charge to full. Check that the battery level shows correctly.
This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.
Maintenance check
Signs it's time to replace
- 01Much shorter run time per charge
- 02Device will not hold a charge or shuts off early
- 03Battery gets unusually hot
- 04Swelling or leaking (stop using it)
More parts for Sony PSP 2000 Series
See all Sony PSP 2000 Series parts
FP-03F2A0
FP-0C6D2E12 month warranty on every part
Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.
Customer reviews
No reviews yet
Bought this part? Be the first to share how it fit and how it held up.
Questions & answers
+Which models does this console battery fit?
Our team verified it for Sony PSP 3000 Series, Sony PSP 2000 Series, Sony PSP-S110. The full list is in the compatibility table above.
+How do I make sure it fits my exact model?
Find the model number on your device label and compare it with the table above. Our fit guarantee covers verified models.
+What is the battery capacity?
Listed capacity: 1800mAh. A capacity that differs from your original changes run time, not fit.
+What battery chemistry is it?
Listed type: Lithium-ion (Li-ion). Replace with the same chemistry as your original battery.
+What voltage does it use?
Listed voltage: 3.6V / 3.7V. It must match the voltage of your original part.
+Is it hard to install?
Install difficulty: Moderate · basic hand tools. Step by step instructions are on this page.
+How fast will it arrive?
US orders arrive in 7 to 15 business days with free shipping. Other countries are shown at checkout.
+Is there a warranty?
Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.