Skip to content
Fitly Parts
FP-59C61F25

Rear Right Power Window Regulator with Motor compatible with Kia Sorento 2016-2020

Rear Right Power Window Regulator with Motor
No reviews yet
Window Regulators
For Kia Sorento
Fits model years 2016–2020
Skill levelAdvanced · mechanical experience needed

Rear right power window regulator assembly including the motor. Replaces OE part number 83481-C6000 and 83481-C5000.

Key facts

Part type
Window Regulator With Motor
Type
Aftermarket replacement

Compatibility matrix

Only models verified by our team are listed
This one part fits every model listed below. No need to open each model, just add this item to your cart.
Parts forModelThis part
KiaKia Sorento Fits

Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.

Where to find your model number

  • Kia: Use your 17-character VIN. It's on the driver-side dashboard at the base of the windshield and on the driver's door jamb sticker. The year is in the 10th character. Also check your registration or the owner's manual.

General manufacturer guidance: exact label position can vary by model.

Window Regulator With Motor specifications

Position
Rear Right
Material
Plastic, Metal
Includes
Motor

Installation guide - Replacing a window regulator or motor

General guidance for this part type - always follow your device manual
Tools
  • Socket set
  • Plastic trim tools
  • Strong tape
Tips
  • Some cars need the window's auto up function reset by holding the switch up after fitting; see your owner's manual.
  1. 1Make it safe. Engine off. If the window still works, lower it until the glass bolts show through the access holes.
  2. 2Remove the door panel. Undo the screws in the armrest and handle bezel, pop the clips round the edge, unplug the switches and peel back the weather sheet.
  3. 3Secure the glass. Undo the glass clamp bolts, slide the glass up by hand and tape it to the door frame so it cannot drop.
  4. 4Swap the regulator. Unplug the motor, undo the regulator bolts and work it out through the largest opening. Fit the new one the same way and loosely fit its bolts.
  5. 5Test before tightening. Reconnect the switch, run the window up and down, align it, then tighten all bolts and refit the panel.

This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.

More parts for Kia Sorento

See all Kia Sorento parts
Thermostat Housing compatible with Hyundai Santa Fe, Sonata, Tucson; Kia Optima, SorentoFP-000052
Fits 5 models
For Hyundai Santa Fe, Sonata
Thermostat Housing
$54.99
Crankshaft and Bearing Set compatible with Hyundai Santa Fe; Kia SorentoFP-0AFED1
Fits 2 models
For Hyundai Santa Fe; Kia Sorento
Crankshaft and Bearing Set
$646.99
Engine Rebuild Overhaul Kit compatible with Hyundai Azera, Santa Fe; Kia Cadenza, Sedona, SorentoFP-39B4F8
Fits 5 models
For Hyundai Azera, Santa Fe; Kia Cadenza
Engine Rebuild Overhaul Kit
$1800.99
Engine Rebuild Crankshaft and Rod Kit compatible with Hyundai Santa Fe, Sonata, Tucson; Kia Optima, Sorento, SportageFP-53E81F
Fits 6 models
For Hyundai Santa Fe, Sonata
Engine Rebuild Crankshaft and Rod Kit
$847.99
Inlet Intake Manifold compatible with Hyundai Sonata, Tucson; Kia Optima, SorentoFP-62D9C8
Fits 4 models
For Hyundai Sonata, Tucson; Kia Optima
Inlet Intake Manifold
$239.99
Upstream and Downstream Oxygen Sensors compatible with Hyundai Santa Fe, Sonata, Tucson; Kia Optima, SorentoFP-63D971×2
Fits 5 models
For Hyundai Santa Fe, Sonata
Upstream and Downstream Oxygen Sensors
$112.99
4PCS TPMS Tire Pressure Sensors compatible with Hyundai Elantra, Genesis, i30, Ioniq, Kona; Kia Niro, Optima, Sorento, SportageFP-907C1E×4
Fits 9 models
For Hyundai Elantra, Genesis
TPMS Tire Pressure Sensors 4PCS i30
$67.99
Intake Manifold compatible with Kia Sedona, SorentoFP-BCB487
Fits 2 models
For Kia Sedona, Sorento
Intake Manifold
$154.99
Air Intake Hose compatible with Hyundai Santa Fe; Kia SorentoFP-DD2ACD
Fits 2 models
For Hyundai Santa Fe; Kia Sorento
Air Intake Hose
$109.99

12 month warranty on every part

Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.

Warranty & returns policy

Customer reviews

No reviews yet

Bought this part? Be the first to share how it fit and how it held up.

Questions & answers

+Which models does this window regulator with motor fit?

Our team verified it for Kia Sorento. The full list is in the compatibility table above.

+Which model years does it fit?

Verified for model years 2016–2020. Check the year of your vehicle in the table above.

+How do I make sure it fits my exact model?

Find the model number on your vehicle registration or VIN and compare it with the table above. Our fit guarantee covers verified models.

+What is the window regulator with motor made of?

Listed material: Plastic, Metal.

+Is it hard to install?

Install difficulty: Advanced · mechanical experience needed. Step by step instructions are on this page.

+How fast will it arrive?

This part is in stock in the USA: delivery within 3 to 8 business days, free shipping in the US.

+Is there a warranty?

Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.

$302.99
1