Bottom Base D-E Cover compatible with HP EliteBook 8460P, EliteBook 8470p
Replacement D-E cover housing (bottom base and door) for HP EliteBook laptops. Includes the lower casing components to restore your device's chassis integrity.
Key facts
- Part type
- LCD Back Cover Front Bezel Palmrest Hinges
- Type
- Aftermarket replacement
Compatibility matrix
Only models verified by our team are listed| Parts for | Model | This part |
|---|---|---|
| Hp | HP EliteBook 8460P | Fits |
| HP EliteBook 8470p | Fits |
Only the models listed above have a confirmed catalog fit. If yours is absent, compatibility is unknown, not ruled out. Compare the exact model identifier and any published dimensions or connectors before ordering.
Where to find your model number
- Hp: Usually on the rating label under or on the back of the device. Your owner's manual also lists the model number.
General manufacturer guidance: exact label position can vary by model.
Installation guide - Replacing a laptop hinge, cable or cover
General guidance for this part type - always follow your device manual- Small Phillips screwdriver
- Plastic opening picks
- Plastic spudger
- Flicker that comes and goes with the lid angle means the video cable is pinched or not fully seated.
- 1Prepare and open. Shut the laptop down fully (not sleep) and unplug the charger. Remove every screw from the bottom cover, including any under rubber feet or labels, then release the clips with a plastic pick starting at a corner near the hinge.
- 2Disconnect the battery first. Unplug the battery connector from the board by pulling the plug body straight out, parallel to the board, never by its wires.
- 3Free the display. Unplug the video cable and the wireless antenna leads, then remove the hinge screws while a hand supports the screen so it cannot fall.
- 4Swap the part. Bezels are clipped or lightly glued; release them from a corner with a pick. Route a new video cable through the hinge along exactly the same path as the old one, with no twists or pinch points.
- 5Test through the full range. Reassemble loosely, power on and open and close the lid fully while watching the picture. Only then tighten every screw.
This is general guidance for the part type, not a model-specific procedure. If the part does not fit without force, stop and recheck compatibility.
More parts for HP EliteBook 8460P
See all HP EliteBook 8460P parts
12 month warranty on every part
Every part we sell is covered for 12 months from delivery. If it fails in normal use, we replace it or refund you , claim it straight from your order page.
Customer reviews
No reviews yet
Bought this part? Be the first to share how it fit and how it held up.
Questions & answers
+Which models does this lcd back cover front bezel palmrest hinges fit?
Our team verified it for HP EliteBook 8460P, HP EliteBook 8470p. The full list is in the compatibility table above.
+How do I make sure it fits my exact model?
Find the model number on your device label and compare it with the table above. Our fit guarantee covers verified models.
+Is it hard to install?
Install difficulty: Advanced · mechanical experience needed. Step by step instructions are on this page.
+How fast will it arrive?
US orders arrive in 7 to 15 business days with free shipping. Other countries are shown at checkout.
+Is there a warranty?
Yes, a 12-month warranty is included, and you can extend it at checkout. Returns are accepted within 30 days.